If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am not sure what u mean.... (I aint that clued on as u can tell by my fabrication)
I just bolted it in with four bolts and a rubber ring in between...
Hope that answers ur question....
just wondering how it sitts on to the air flow
it needs to be air tight /water tight
coz if water comes over the bonnet your safe
unless it sucks water in from were its joins up
be carefull dude
just wondering how it sitts on to the air flow
it needs to be air tight /water tight
coz if water comes over the bonnet your safe
unless it sucks water in from were its joins up
be carefull dude
rubber hose and clips..
going to put it on in a bit will make a picture when done....
But, what I mean is that it presumably has a hose going into the air filter, otherwise it's just a funny thing sticking out of your bonnet. Too short a hose and it'll tear off when you open the bonnet. Too long and it'll kink, foul something and probably get burned when you close the bonnet. I don't think there would be a 'just right'
But, what I mean is that it presumably has a hose going into the air filter, otherwise it's just a funny thing sticking out of your bonnet. Too short a hose and it'll tear off when you open the bonnet. Too long and it'll kink, foul something and probably get burned when you close the bonnet. I don't think there would be a 'just right'
yeah I am getting a hose today but might have to have a screwdriver ready when opening the bonnet....
It's only for the weekend tho after that I am getting a new bonnet and it will be done proper soon....
Comment