If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Dont worry bout paying for rods you are welcome to them, I've got loads. If I have no joy on Monday or you are not sorted, what I can do for you is cut some out by hand.What you can do is either tack them onto your tube,or weld say three or four tabs on the plates they can go into the id of the tube to be riveted self tapped or bolted etc.
OK cheer's i'll have a wander round the cheap shops with my tape measure monday seee what i can find, if i have no luck i'll give you a shout dave, thanks
Tweet
Comment