milner heads?

[alisonb]

hi all, does anyone here recommend milner offroad for a new cylinder head? new thermostat and cap fitted but guy at Head Racing Development in witchford cambs reckons that it will be a miracle if we escape without cracking the head.

[Woodzie]

hi all, does anyone here recommend milner offroad for a new cylinder head? new thermostat and cap fitted but guy at Head Racing Development in witchford cambs reckons that it will be a miracle if we escape without cracking the head.

For a honest answer go to stevo .......




or tonyn who will fit a stevo head

[Woodzie]

For a honest answer go to stevo .......




or tonyn who will fit a stevo head

Have you had the cooling fluids tested for exhaust gases as you my get away with the usual suspects . Thermostat , rad cap ...etc.

[Tallyman]

Definitely go with Woodzie. Either Stevo or TonyN for a 100% good job.

[plumb bob]

Try here.



http://www.yotasurf.co.uk/members_pa...evo/index.html

[Woodzie]

Try here.



http://www.yotasurf.co.uk/members_pa...evo/index.html

STEVO AGAIN......

[M35A2]

I got my 3.0lt head from Stevo, and so far so good. I looked on ebay and there are a lot of places that sell heads. Some as low as £250, but I can't see them being any good. There was one guy that was offering "genuine" heads for around £500. I suppose unless you actually buy one from Toyota you always run the risk of someone passing off a pattern head as a genuine item. It is a worry. Stevo was about £200 cheaper than Toyota for the same genuine head.

I would give him a call.

[AuldNick]

Got mine from Ebay, under £300 complete with fitted re cut valves, gaskets, head bolts, "free" water pump and timing belt.

[M35A2]

Got mine from Ebay, under £300 complete with fitted re cut valves, gaskets, head bolts, "free" water pump and timing belt.

How long have you had that head fitted for? Any problems? What was the quality like?

[Medieval Dave]

hi all, does anyone here recommend milner offroad for a new cylinder head? new thermostat and cap fitted but guy at Head Racing Development in witchford cambs reckons that it will be a miracle if we escape without cracking the head.

On the bright side, I've had radiators fail twice. the first time through damage, and the second time through the replacement radiator blowing apart.

Both failures were at speed on the motorway, and both resulted in the temperature needle all the way to the right. the first time was 10 months and 20 +,000 miles ago, the second was about 2000 miles ago.

Everything has been fine, so I guess mine had the head replaced with a modded one before I got it.

[LURCH]

Definitely go with Woodzie. Either Stevo or TonyN for a 100% good job.

NEVER EVER GO WITH WOODZIE YOU WILL GO MAAAAAAAAAAAAD.

[colin timney]

i think the lad who fixed mine got the head from milners,it seems alright just everything else is falling to bits now.
colin

[Antshiel]

Stevo for a top notch job

[Rabbie]

got mune from milners 3 year ago and it has been fine. no worries with it at all.