sounds like a scania

[slydog]

sorted twin pipes stainless freeflow . sounds like a v8 scania lol

[surfenstein]

sorted twin pipes stainless freeflow . sounds like a v8 scania lol

is that with or without the eminox exhaust?

[slydog]

mmmmmm

without it m8 lol

[surfenstein]

niceeeeeeeeee.so sly hope you dont mind me asking but what sort of wonga did the exhaust set you back,and where on the system does it split.

[slydog]

split

it was 350 all in . it splits just over the rear axel and exits straight out the back either side with 2 3 inch stainless rolled tips . . the blokes done a great job . il take some pics when i grab a camera m8

[surfenstein]

yea that would be good,can you do a couple of pics from underneath so that i can see where it splits and how they travel on the chassis.and how the mounting point were fabbed up.cheers

[slydog]

no probs

yep will do m8

[bundubasher]

"Sounds" great!

Do you get any better performance? Faster response, more power that sort of thing?

[slydog]

yep

yes it seems to be a tad more responsive and seems to rev more freely . definatly better acceleration . its straight through really just a very small freelowing box halfway down . i will post the pics when i can work out how to downsize them .

[slydog]

pics

i hope it works and if there not what you want let me know il take some more

[surfenstein]

cheers dog that will do nicely,its a bit of a rough job though aint it.

[slydog]

mmmmmm

do you think so . they are higly recommended pipecraft in basildon been going years doing yank cars and was recomended by lucky on this site as well . as long as i cant see it lol

[surfenstein]

do you think so . they are higly recommended pipecraft in basildon been going years doing yank cars and was recomended by lucky on this site as well . as long as i cant see it lol

hehe,nah im only pulling your leg,it can be a bitch to weld stainless at the best of times,especially if you havnt got a tig welder.it looks good mate honest.and like you say if you cant see it.

[slydog]

phew

blimy was all ready to steaming back there tomorrow doin me nut lol he said you cant help the creases in the bends as if it was mild steel you wouldnt get it but it happens with stainless .

[dirtydog]

i was looking at pipecraft a while back too - prob my nearest place to get it done