Springs

[Nkerridge]

People have just changed my rear springs today, with the 20% stronger
milners springs. No problems with the fitting thanks to the website.
BUT !! The right rear spring does not fit snug on the bottom rubber, the rubber
itself fits spot on, it just looks like the spring looks too small at the bottom
Can i leave it as its not that far out, or could it work itself right or start
again and refit it

[BUSHWHACKER]

Have you checked to see what it looks like with the weight of the truck on the ground?

[Nkerridge]

Have you checked to see what it looks like with the weight of the truck on the ground?

do you mean jacked up in the middle of the axle

[BUSHWHACKER]

Idealy with all four wheels on the ground is best way to check.
It should 'seat' it's self then.

[Nkerridge]

Idealy with all four wheels on the ground is best way to check.
It should 'seat' it's self then.

Cheers vince I will try that tomorrow

[Hawaii]

Have you checked that they have put the spring in the right way up. If I remember rightly, they have a flat end and a rounded end & the flat end goes uppermost (does that make sense)

It will seat if it's the wrong way up but not as snugly

hope this helps

ta

hawaii

[Nkerridge]

Have you checked that they have put the spring in the right way up. If I remember rightly, they have a flat end and a rounded end & the flat end goes uppermost (does that make sense)

It will seat if it's the wrong way up but not as snugly

hope this helps

ta

hawaii

It was the first thing i checked