Tweet
Hi Dave, try'd pming but it wont work, prob recinded as i'm over due me subs,
anyway just to let ya know the bend arrived today, thanks mate and for the rods as well, if you pm me your postal addy (if it works) i'll get a cheque (if thats ok) off to you for the tube, bits, and carrage etc, wall thickness is just right! even i should be able to arc weld it with going through, thanks again Dave, regards ian
Dave! i've been thinking, if you have'nt ordered the tube yet and it's not any bother could you add another 4 x 90 degree bends and i'll pay ya for the lot?
of course if you've already ordered it never mind, perhaps we could arrange it a bit later, i'm thinking i might as well have a go at doing the whole exhaust instead of just the back bit, seen some 3"flexi's and a box on eblag,
sorry to be a pain in the backside
anyway just to let ya know the bend arrived today, thanks mate and for the rods as well, if you pm me your postal addy (if it works) i'll get a cheque (if thats ok) off to you for the tube, bits, and carrage etc, wall thickness is just right! even i should be able to arc weld it with going through, thanks again Dave, regards ian
Dave! i've been thinking, if you have'nt ordered the tube yet and it's not any bother could you add another 4 x 90 degree bends and i'll pay ya for the lot?
of course if you've already ordered it never mind, perhaps we could arrange it a bit later, i'm thinking i might as well have a go at doing the whole exhaust instead of just the back bit, seen some 3"flexi's and a box on eblag,
sorry to be a pain in the backside